SUGGESTED SPECIFICATIONS FOR ARCHITECTS AND ENGINEERS:

Single Unit (1/3 HP 1/2 HP UNITS)

Furnish and install where shown on plans, a single Type P submersible sump pump unit, as manufactured by Federal Pump Corporation. Pump to have a capacity of____ G.P.M. against a total dynamic head of ____ ft. Pump to have ____ N.P.T. discharge connection and to be standard-fitted construction with submersible sealed motor, stainless steel shaft and waterproof power cable. Motor to be ____ H.P., 1-ph., 60 cy., ____ volts, 1750 RPM, with integral fully submersible float switch, for automatic control of the pump.

Furnish a welded angle iron grouting frame and heavy steel cover equal to Federal Type PF-1, for a concrete pit ____ ins. x ____ ins. x ____ ins. deep. Cover and frame to be treated witn corrosion resistant coating and cover to have openings for cable, vent connection and pump removal plate.

SUGGESTED SPECIFICATIONS FOR ARCHITECTS AND ENGINEERS:

DUPLEX UNIT, (1/3 HP 1/2 HP UNITS)

Furnish and install where shown on plans, a duplex Type P submersible sump pump unit, as manufactured by Federal Pump Corporation. Each pump to have a capacity of____ G.P.M. against a total dynamic head of ____ ft. Pumps to have ____ N.P.T. discharge connections and to be of standard-fitted construction with submersible sealed motor, stainless steel shaft and waterproof power cable. Motors to be ____ H.P., ____ phase, 60 cycles, ____ volts, 1750 RPM. Each-pump shall have a fully submersible float switch for mounting on the pump discharge pipe.

Furnish a duplex pump control panel in a single NEMA-1 enclosure, including fusible disconnect switch, magnetic starter and hand-off-automatic selector switch for each motor and an automatic alternator to alternate the sequence of eration of the two pumps and provide simultaneous operation of the pumps when required.
Furnish a fiberglass (or cast iron or steel) sump basin, ____ ins. in diameter x ____ ins. deep, with inlet connection as determined by job conditions. The basin shall have a steel cover with required openings for pump removal plates, controls and vent connection, and shall be treated with a corrosion resistant coating.