Features

FLEXIBLE COUPLING: Machined and balanced.

THRUST BEARING: Ball bearing mounted above suspension plate in dust-proof and moisture-proof housing.

ADJUSTING NUTS: Two bronze lock nuts for accurate vertical adjustment of impeller clearance.

SUSPENSION PLATE: Cast iron suspension plate has integral strengthening ribs.

DISCHARGE PIPE: Wrought steel, locked to suspension plate, held in bottom elbow by slip-bolt mating flange.

TOP DISCHARGE ELBOW: Cast iron 45 degree elbow with integral 125# companion flange. Bottom of housing encloses top expansion joint.

STRAINER: Cast iron housing; stainless steel basket easily removable from top. Entire assembly slips out of discharge line without disturbing piping.

INLET TEE: Cast iron tee with three mating flanges for simple assembly.

CONTROL VALVE: Cast iron housing with removable top for easy access; brass flapper. Prevents backing up into house line during discharge cycle. Shut-off handle cuts off either pump.

OVERFLOW FITTING: Permits water to overflow directly into basin if both pumps are operating.

IMPELLER: One-piece cast iron non-clog, dynamically and hyraulically balanced, keyed and locked to shaft. Bronze impellers optional.

SHAFT: Carbon steel, turned, ground, and polished; sized for maximum load.

SUSPENSION LEGS: Cast iron sections with integral end flanges.

INTERMEDIATE GUIDE BEARINGS: For each four feet of shaft length; renewable bronze sleeve type.

CASING: Cast iron with smooth water passages.

LOWER DISCHARGE ELBOW: Removable; acts as elbow and housing for bottom expansion joint.

BOTTOM GUIDE BEARING: Renewable bronze sleeve bearing pressed into casing.

LUBRICATION SYSTEM: Guide bearings lubricated through flexible grease line. Alemite fitting furnished on the suspension plate for each line. Sight-feed and automatic oilers available.