Features
RECEIVER: Heavy welded steel construction, designed for vented operation.
PUMP: Bronze fitted, close-coupled, centrifugal design, with bronze sleeve fully protecting the shaft. Mechanical shaft seals are standard. Maximum water temperature at pump suction is 210°F.
MOTOR: Drip-proof, ball bearing design. Units are avaiable with 1750 RPM or 3450 RPM motors.
FLOAT SWITCH: One for each pump, provides automatic operation; mounted and wired on unit.
STARTER: All polyphase units (208v. or 230/460v.), and integral H.P. single phase units (115/230v.) are furnished with magnetic starters mounted and wired on the unit. Single phase fractional H.P. motors have built-in overload protection and do not require magnetic starters.
Highlights
- Heavy steel receivers
- 1750 Or 3450 RPM operation
- To 150,000 sq. Ft. E.D.R.
- To 125 P.S.I.G. discharge pressue
- Centrifugal pumps
- Completely assembled
- Controls mounted and wired
Modifications List
ALTERNATING FLOAT SWITCH (Replaces the two standard float switches on a duplex unit, to automatically alternate cycle of operation, as well as providing 2-pump operation under peak conditions.)
COMBINATION MAGNETIC STARTER AND DISCONNECT SWITCH
COMBINATION MAGNETIC STARTER AND CIRCUIT BREAKER
SPECIAL ENCLOSURES FOR MOTOR, STARTER AND SWITCH
INLET STRAINER FOR RECEIVER
STRAINER IN PUMP SUCTION LINE
GATE VALVE IN PUMP SUCTION LINE
SPECIAL THERMOMETERS AND PRESSURE GAUGES
GALVANIZING OF RECEIVER
NON-STANDARD RECEIVER SIZES
EXTRA-HEAVY RECEIVER CONSTRUCTION
SPECIAL INTERIOR AND EXTERIOR RECEIVER COATINGS FOR CORROSION INHIBITION
CONTROL PANELS FOR WALL, FLOOR OR UNIT MOUNTING
FRACTIONAL H.P. STARTER FOR SINGLE PHASE UNIT
WALL-MOUNTING ALTERNATOR
LEAD-LAG PUMP SELECTION
SPECIAL RECEIVER TAPPINGS
MANHOLE AND BAFFLES FOR RECEIVER
FLEXIBLY-COUPLED PUMP IN LIEU OF THE STANDARD CLOSE-COUPLED PUMP
TANK DRAIN VALVE
MAGNESIUM CORROSION-INHIBITING ANODE BAR
SEE TYPE BFC FOR COMPARABLE UNITS FOR BOILER FEED SERVICE WITH MAKE-UP WATER VALVE