To confirm information about any of our products please contact a specialist by calling or emailing us directly.
Telephone: (718) 451-2000
Email: general@federalpumps.com
NON-STANDARD TANK SIZES: Units can be furnished with tank capacities other than shown in the selection table. Diameters and lengths of receivers can be modified where required by space conditions. Return inlet height and location can be modified.
GALVANIZING OF RECEIVER: Hot-dip galvanized inside and outside.
SPECIAL RECEIVER COATINGS: Special interior and exterior coatings where job conditions require extra corrosion resistance.
INTERIOR TANK BAFFLES: Built into tank to prevent air or sludge from entering pump suction.
SPECIAL RECEIVER TAPPINGS: Special or additional tappings as required.
MANHOLE: Manhole and bolted cover for clean-out and inspection.
DRAIN VALVE: Tank drain connection can be fitted with bronze drain valve.
EXTERNAL FLOAT CHAMBER MAKEUP VALVE: Mounted on end of receiver with 3-valve by-pass piping to permit manual and automatic makeup water control. Has built-in strainer.
SOLENOID OPERATED MAKEUP VALVE: Furnished with reverse-acting float switch in receiver to actuate the solenoid valve. Requires electric service for operation and is furnished with makeup water strainer. Can be furnished with air gap and 3-valve by-pass, if required.
CORROSION INHIBITOR BAR: Magnesium anode bar in the receiver to inhibit electrolytic corrosion; with drip-hole to indicate when bar has been completely corroded and requires replacement.
FEED WATER HEATERS: Submerged perforated brass feed water heater pipe, operated by temperature sensor and regulating steam valve.
SPECIAL THERMOMETER: Standard column type can be replaced by special thermometers as specified.
NON-STANDARD MOTOR CONTROLS: "Hand-off-Automatic" selector switch, pilot light and control circuit transformer for motor starters; waterproof or explosion-proof enclosures for starters; combination magnetic starters and disconnect switches, plus combination magnetic starters and circuit breakers.
PRESSURE GAUGES: Pump discharge pressure gauges available.
NON-STANDARD MOTOR ENCLOSURES: Standard enclosures are drip-proof. Totally enclosed and explosion-proof enclosures are available.
TRANSFER SWITCHES: To alternate pump operation or transfer pump-boiler relationship in multiple-boiler installations.
CONTROL PANELS: Control components can be mounted on factory-wired wall-mounting or floor-mounting panel, in lieu of individual wall-mounting enclosures.
LARGER UNITS: For ratings in excess of 750 Boiler H.P. and discharge pressures in excess of 200 psig, up to a maximum of 400 psig, consult factory or nearest Federal Pump representative.
OVERFLOW LOOP: An overflow loop can be piped from the tank head, if required.
WATER LEVEL ALARMS: A high water alarm and/or low water alarm float switch can be furnished in the receiver with alarm station and/or pump cutout circuit.
GATE VALVES: A gate valve can be installed in each pump suction line, if required.